Manual sh 300

Page 18 Load limits Following are the load limits for your scooter: Maximum weight capacity: kg lbs Includes the weight of the rider, passenger, all cargo and all accessories. Maximum cargo weight: 19 kg 42 lbs The weight of added accessories will reduce the maximum cargo weight you can carry. Putting too much weight in individual storage compartments can also affect stability and handling. Page 20 Before consider making specifically designed and tested for your modifications or adding an accessory, be scooter.

Because Honda cannot test all other sure to read the following information. Their functions are described in the tables on the following pages. Page 26 Ref. Description Function 1 Coolant temperature gauge Shows coolant temperature page The coolant temperature gauge needle wil swing to the maximum scale on the dial once when the ignition switch is turned ON.

Page 27 RUN. If it comes on at any other time, reduce speed and take the motorcycle to your Honda dealer as soon as possible. Page 28 Ref. Description Function 10 Multi-function display The display includes the following functions; This display shows the initial display page Page 30 Initial Display When the ignition switch is turned ON, the multi-function display 1 will temporarily show all the modes and digital segments so you can make sure the liquid crystal display is fuctioning properly.

Page 32 Digital Clock 3. Turn the ignition switch ON. Shows mileage per trip. There are two tripmeters, tripmeter A 2 and tripmeter B 3. Switch between the A and B displays by pressing the Tripmeter reset button 4 repeatedly. Resetting the tripmeter To reset the tripmeter, push and hold the Tripmeter reset button 4 with the display in the tripmeter A or tripmeter B mode.

Page 34 Coolant temperature gauge The coolant temperature gauge 1 shows coolant temperature. Page 35 Fuel gauge The fuel gauge 1 shows the approximate fuel supply available in a graduated display. When the gauge needle enters the red band 2 , fuel will be low and you should refill the tank as soon as possible.

The amount of fuel left in the tank,with the vehicle set upright, when the needle enters the red band is approximately Page 36 Oil change indicator The oil change indicator 1 illuminates when the distance covered by the scooter arrives at the oil change interval specified in the user and maintenance table program page Reset the indicator after every oil change, as follows.

Page 37 NOTE The first oil change is at km miles , but in this case the indicator should not be reset. The indicator will appear after the scooter has covered approximately km miles for the type E. Therefore, after the second engine oil change as prescribed by the maintenance table page 81 remember to reset the oil change indicator page Use a pin spanner 2 to adjust the rear shock.

Always adjust the shock absorber position in sequence or Operating the rear brake lever applies the rear brake and a portion of front brake. This model is also equipped with an Anti-lock Make sure you observe the prescriptions Brake System ABS designed to help prevent wheel lock up during hard braking on uneven concerning tyres page The ABS indicator may illuminate if the rear This indicator normally illuminates when the wheel is driven at high speed for more than ignition switch is set to ON and is extingui Page 42 As the brake pads wear, the brake fluid level drops.

The recommended brake fluid is Honda There are no adjustments to perform, but DOT 4 brake fluid from a sealed container, fluid level and pad wear must be inspected or an equivalent. Page 43 page Worn pads must be replaced. If the pads are not worn, have your brake system inspected for leaks. This coolant solution is recommended for The owner must properly maintain the most operating temperatures and provides coolant to prevent freezing, overheating and corrosion.

Page 45 The reserve tank is located underneath, on loss is excessive, check for leaks and see the left hand side of the footrest. Page 46 Removing the footrest cover Removing the coolant tank compartment 1. Remove the two screws 1. Remove the footrest cover with care 2.

Remove screw 1. To replace it, perform the above 2. Lift up the coolant compartment cover 2 operations in reverse order. Fuel tank capacity is: 9. Do not overfill the tank. If spark knock or pinking persists, consult your Honda dealer. Failure to do so is considered misuse, and damage caused by misuse is not covered Honda cannot endorse the use of is at least as high as that recommended by Honda.

Generally, inflated for the load you are carrying. Page 53 Tread Wear Replace tyres before tread depth at the centre of the tyre reaches the following limit: Minimum tread depth Front: 1. Page 54 Tyre repair Even if a tyre is professionally repaired with If a tyre is punctured or damaged, you a permanent internal patch plug, it will not be as good as a new tyre. Excessive heat build-up can cause the tube to burst. The rims are designed for tubeless tyres and during hard acceleration or braking a tube-type tyre could slip on the rim and cause the tyre to rapidly deflate.

Page Essential Individual Components ON and the engine is not running, the headlight and taillights will still be on, resulting in battery discharge.

Key Position Page 58 Store the plate in a number plate. To reproduce keys, bring all keys, key number plate and scooter to your Honda dealer. Up to four keys can be registered with the immobilizer system HISS , including the ones in hand. To avoid this possibility we recommend that if only one key is left, you immediately have it reproduced to ensure that a back up is available. These keys contain electronic circuits that are activated by the immobilizer system HISS.

If the indicator Page 61 The immobilizer system HISS indicator 1 When the ignition switch is turned ON, the can continue to flash every 2 seconds during indicator light function is deactivated.

Once the time has elapsed, the indicator If you removed the battery, after you have lamp switches off automatically. Page 62 If the system repeatedly does not recognize EC Directives the coding of your key, contact your Honda This immobilizer system complies with the dealer. When the starter button is pressed, the throttle grip. When the switch is in the starter motor cranks the engine. Passing light control switch 2 When this switch is pressed down, the headlight flashes on to signal approaching cars or when passing.

Remove the ignition key. To unlock the steering turn the ignition key to OFF. To open the seat, insert the ignition key 2 , push in the key and turn to the OFF position, then turn it counterclockwise.

Lift the seat. To lock the seat, lower and push down on the reverse side of the hook 3 of the seat until it locks. The helmet holder is located below the seat. Open the seat page Hook the loops of the wire onto the helmet holder 3 and lower the seat to lock.

The center compartment may become heated by the engine. The maximum allowable load in the left compartment shall be no more than: 0. Open the cover 2 to gain access to the accessory socket. Rated capacity is: 12 watt 12 volt, 1amps. To prevent battery run down or weak battery, keep the engine running while drawing current from the socket. Obey local laws and regulations. Page 73 If you detect any problem, be page Check for leaks. Coolant level - add coolant if required. Check for leaks pages Front and rear brakes - check operation; Page 74 7.

Engine stop switch- check for proper function page Side stand ignition cut-off system - check for proper function page High levels of carbon described below.

Do not run the This scooter has a fuel-injected engine with engine with the garage door closed. Place the scooter on its center stand.

Operating the engine with insufficient oil 2. Make sure that the engine stop switch is pressure can cause serious engine damage. Turn the ignition switch 1 to ON. Page 77 4. Squeeze the rear brake lever 2. With the throttle completely closed, push The electrical starter will only work when the start button 3.

Release the starter the rear brake lever is squeezed and the button as soon as the engine starts. Page 78 6. Be sure to keep the throttle closed locked while warming up the engine.

Make sure the throttle 1 is closed Review scooter safety pages before before moving the scooter off the center stand. Stand on the left side of the scooter Make sure flammable materials such as and push it forward off the center stand. Page 81 3. Mount the scooter from the left side keeping at least one foot on the ground to steady the scooter.

Page 82 4. Before starting off, indicate your 5. To accelerate, open the throttle 1 direction with the turn signals, and check gradually; the scooter will move forward. Page 83 7. When slowing down the scooter, Both front and rear brakes should be coordination of the throttle 1 and front applied together. Independent use of only the front or rear brake reduces stopping 2 and rear brakes 3 , is most important.

Page 84 8. When approaching a corner or turn, 9. After completing the turn, open the close the throttle 1 fully, and slow the throttle gradually to accelerate the scooter down by applying both front 2 scooter. Page 85 When descending a steep grade, Avoid continuous use of the brakes, close the throttle 1 fully and apply both which may result in overheating and reduction of braking efficiency. Page 86 When riding on wet or loose surfaces, be especially cautious.

After stopping the scooter turn the front of the scooter uphill to reduce the ignition switch to the OFF position and possibility of rolling off the center stand or remove the key. Page 88 4. This scooter is equipped with pre-wiring for Honda anti-theft alarm. Please contact your dealer to install a genuine Honda alarm accessory.

It dealer inspects all major parts, even if you will also help reduce air pollution. Page 90 Wheel removal should normally be handled only by a Honda technician or other qualified mechanic; instructions are included in this manual only to assist in emergency service. Page 91 Let the engine and exhaust system cool before touching.

Page 92 Honda by properly trained and equipped technicians. Your Honda dealer meets all of these requirements. Refer to the Official Honda Shop Manual. Some roadside repairs, minor adjustments and parts replacement can be performed with the tools contained in the kit. The engine serial number 2 is stamped on They may also be required by your dealer when ordering replacement parts.

It is helpful when ordering replacement parts. Record the colour and code here for your reference. First remove the air filter from the drive Refer to the Safety Precautions on page The air cleaner should be serviced at regular 2. Remove the seven screws 2 from the air intervals page Page 99 3. Remove the air filter 4 , unfastening the three internal screws 5. Dispose of the filter, and fit a replacement. The product also has a 12v socket, where in times of need it is possible to charge the cell phone in the storage compartment.

It cannot be denied that the Honda SH i scooter is the strongest, logically due to the There is nothing better to face unfair competition from thugs with four or more wheels in the traffic of large cities. To buy a motorcycle without disastrous consequences as to what it offers and the need for the rider it is important to calmly analyze all the items that the product offers.

To find out the details of the SH i, see the complete product datasheet:. Knowing the autonomy of the motorcycle is the main factor to influence the purchase of a motorcycle.

This is due to the reason that this value will be present monthly in the family income, so it is always important to research.